Tools · 3D printing

Power block mount

Open full screen ↗

Two mirrored brackets hold a power block against a wall. Each one is a small shelf with a front lip and a side wall, and screws on through a back plate.

  • Shelf: set its depth, width and front lip height, and a clearance for your printer.
  • Walls: lip and side wall thickness, back plate and shelf thickness, back plate height and edge rounding.
  • Screws: two per bracket. Set the hole and head diameters and how deep the head sits; the holes go right through and the head ends up below the surface.

Everything runs in your browser. The first load fetches the OpenSCAD engine (about 11 MB), so give it a moment. The brackets print on their side, so the preview is turned 90° from how they mount.

Status
beta
Runs
In your browser
Engine
OpenSCAD (WebAssembly)
Output
3MF, OpenSCAD source