Tools · 3D printing

Laptop mount

Open full screen ↗

Four brackets hold a laptop on its edge against a wall: two corner brackets for the bottom corners and two clamps, each a mirrored pair. The laptop slides into a slot between a back plate on the wall and a front plate with hex vents.

  • Laptop: set its thickness and a fit clearance.
  • Size: the corner bracket and clamp sizes.
  • Screws: three per bracket, countersunk from the laptop side. Set the hole and countersink diameters.
  • Vents: hex vents in the front plates, shaped with 45° points so they print without supports. Turn them off, or change the cell size and margins under Advanced settings.

Everything runs in your browser. The first load fetches the OpenSCAD engine (about 11 MB), so give it a moment. The brackets print lying down, so the preview is turned 90° from how they mount.

Status
beta
Runs
In your browser
Engine
OpenSCAD (WebAssembly)
Output
3MF, OpenSCAD source